Description

DS200TCQBG1BCB – BOARD- (RST)EXTENDED ANA. I is available in stock which ships the same day.

　　DS200TCQBG1BCB – BOARD- (RST)EXTENDED ANA. I comes in UNUSED as well as REBUILT condition.

　　To avail our best deals for DS200TCQBG1BCB – BOARD- (RST)EXTENDED ANA. I, contact us and we will get back to you within 24 hours.

　　Product Description

The GE RST Extended Analog I/O Board DS200TCQBG1BCB is populated with a programmable logic device and EPROM modules. The GE RST Extended Analog I/O Board DS200TCQBG1BCB also has 1 OK LED that is viewable from the side, 1 50-pin connector, and 15 jumpers. The ID assigned to the 50-pin connector is JKK. The IDs assigned to the 34-pin connectors are 3PL and JLL. During the board replacement procedure you must remove the cables from the defective board and connect the cables to the replacement. There is some information about the cables connected to the 50-pin and 34-pin connectors that you must consider before you begin.(https://www.weikunfadacai1.com/)

The 50-pin connector and the 34-pin connectors use ribbon cables to connect to other boards in the drive. The 50-pin and 34-pin ribbon cables carry signals that are processed by the board. Some of the signals are received by the board for processing. Other signals are transmitted by the board and processed by other boards in the drive interior.

 

The ribbon cables can be damaged if mishandled. Only hold the ribbon cable by the connector at the end of the cable when you disconnect it from the board. If you pull the ribbon cable out like a rope you can easily cause the fine copper wires to pull out from the connector. You will notice that the connector at the end of the ribbon cable provides little support to the ribbon cable.

When you connect the ribbon cable, align it with the connector and press it into the connector. Visually inspect the connection and if you see space between the connectors, apply more pressure to the connection.

DS200TCQBG1BCB is an RST Extended Analog I/O Board and is part of the GE Speedtronic Mark V gas turbine control systems. A programmable logic device and EPROM modules are installed on the RST Extended Analog I/O Board DS200TCQBG1BCB. The GE RST Extended Analog I/O Board DS200TCQBG1BCB also has a side-mounted OK LED, a 50-pin connector, and 15 jumpers. JKK is the code for the 50-pin connector. 3PL and JLL are the IDs allocated to the 34-pin connectors. You must disconnect the cables from the faulty board and attach them to the replacement during the board replacement procedure. Before you begin, there is some information regarding the cables that connect to the 50-pin and 34-pin connections that you should know.(https://www.weikunfadacai1.com/)

Ribbon cables are used to link the 50-pin and 34-pin connectors to other boards in the drive. Signals are carried by the 50-pin and 34-pin ribbon cables, which are processed by the board. The board receives some of the signals and processes them. The board transmits other signals, which are handled by other boards in the drive interior.

　　FREQUENTLY ASKED QUESTIONS

　　Which device is Installed in DS200TCQBG1BCB?

The programmable logic device and EPROM modules are installed on the RST Extended Analog I/O Board DS200TCQBG1BCB.

　　What is the code for the 50-pin connector?

JKK is the code for the 50-pin connector.

　　Which of the following IDs are allocated to 34-pin connectors?

3PL and JLL are the IDs allocated to the 34-pin connectors.

　　Model recommendation:

GE DS200TCPSG1AEE