Description

 

　Product Description

The IS200AEBMG1AFB circuit board is a circuit board component manufactured as part of the GE Speedtronic Mark VI turbine control system. This distributed control system is sold by General Electric as a complete solution for the control and management of hydraulic, steam, and gas industrial turbine systems.

IS200AEBMG1AFB consists of a roughly rectangular plate surface installed on a load-bearing frame. This frame is labeled 1151x122OBQ01, making it easier to install circuit boards in rack systems. This board does not include the typical Mark VI front panel and installation hardware used to lock it in place. The installation frame extends beyond the surface of the circuit board by installing multiple screws on any long edge. There are also notches on the circuit board that allow for access to factory drilled holes on the surface of the load-bearing frame. Some of them are used to secure circuit boards to carriers using clips and screws.

The IS200AEBMG1AFB board is marked with a reference name, board ID number, GE logo, and several identification codes, such as 94V0 and E99006. The edges of the board are also marked with+and – symbols and “AC”. These correspond to the screw mounting components on the bearing frame mentioned above.

The components installed on IS200AEBMG1AFB include six vertical plug connectors, four transistors, over forty diodes, over forty resistors using various materials including metal films, and more than ten capacitors. You can use the GE manual or data sheet to find additional information about circuit board components and their use. IS200DSFCG1A is a device called a feedback driver/splitter card. This is a type of PCB (printed circuit board). General Electric has created IS200DSFCG1A as part of the GE Speedtronic Mark VI series.

The IS200DSFCG1A printed circuit board is designed specifically for GE turbine applications. Located near the top left corner of the PCB is one (1) circular red metal oxide varistor or MOV. The identifier LCB is printed on the circuit board near the MOV. A series of black solid resistors are located directly below the MOV. A total of four (4) resistors are placed around black transistors shaped like squares. Adjacent to these components is one (1) small solid red light emitting diode or LED. The word LINK ABOVE 50V is printed on the circuit board directly above the LED. Two (2) large metal components are located near the bottom left side of IS200DSFCG1A. Two (2) metal components are labeled with UGB and UEB labels. There are six (6) jumper pins located near the upper center of IS200DSFCG1A, divided into three (3) pairs. Each pair of jumper pins is labeled with codes such as PL, PL1, and PL2. One (1) larger square component is located in the right half of IS200DSFCG1A. The side of the square component is black, and the top is silver. A series of integrated circuits are placed on the IS200DSFCG1A card. Approximately ten (10) integrated circuits are placed on a PCB, which may be small, medium, or large.

　　Model recommendation:

IS200AEBMG1AFB GE